How do you force Regen a Volvo?
0:052:092020 Volvo VNL 860 Force DPF Regen | OTR Reset Tool 2014YouTubeStart of suggested clipEnd of suggested clipAnd we're going to go ahead and plug in the reset tool and it's going to take anywhere from 30MoreAnd we're going to go ahead and plug in the reset tool and it's going to take anywhere from 30 seconds to about one minute. To. Start now once the reset tool is plugged in the regen.
How do you force a regeneration on a Volvo truck?
Turn engine on and leave engine running during this process.Make sure engine is fully warmed up, parking brake set, truck in neutral, make sure PTO is off. ... Connect OTR reset tool to 9-Pin connection under the dash.Start Forced Regen - Leave plugged for 4 minutes.More items...
How long does a parked regen take on Volvo?
So-called "regeneration" is started in order to burn away the particles and empty the filter. This requires the engine to have reached normal operating temperature. Regeneration of the particulate filter is automatic and normally takes 10-20 minutes. It may take a little longer at a low average speed.
What is ATS on a Volvo?
American Truck Simulator - Volvo Construction Equipment.
How do you do a parked regeneration?
1:182:59Parked Regen GHG17 - Full Training Video - YouTubeYouTubeStart of suggested clipEnd of suggested clipComplete the following steps. One keep engine at slow idle. Cannot be in PTO mode to cycleMoreComplete the following steps. One keep engine at slow idle. Cannot be in PTO mode to cycle transmission out of neutral. And back into neutral. Three cycle the part brake from off to on.
How do you force Regen a Volvo d13?
0:294:58How to Perform a Forced Regen on a Volvo D13 | 2007-2013 - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe're gonna have to have the parking brake engaged. And the PTO switch on the off. Position. We'reMoreWe're gonna have to have the parking brake engaged. And the PTO switch on the off. Position. We're going to plug in the module. Then after four minutes the force region will.
Can you drive while doing a regen?
The only thing required of the driver during this process is maintaining driving speed during the process. If driving speed is interrupted as active regen occurs, you will likely have to restart the process again the next time you are up to speed.
What happens if I stop a regen?
Regeneration, or regen, of the DPF filter, is the process that burns the soot accumulation that is inside the DPF filter. If you can no longer start a regen then you will eventually get stuck in a derate which will then lead to an engine shut down.
How do you force a regeneration?
1:383:04DPF Forced Regeneration Maintenance - YouTubeYouTubeStart of suggested clipEnd of suggested clipItself raising. And lowering the engine RPMs as to clear the filter a forest region can take betweenMoreItself raising. And lowering the engine RPMs as to clear the filter a forest region can take between 20 and 40 minutes depending on the amount of congestion within the filter.
What does ATS mean on a Mack truck?
As you know, trucks are complex pieces of equipment with many components working together to create an efficient, safe and clean machine. The aftertreatment system, or ATS, is one such important part of the truck.