Check-Menus.com

yaesu ft 891 service menu

by Prof. Jeffry Gorczany Jr. Published 2 years ago Updated 2 years ago
image

How do I download the Yaesu ft-891 driver?

Go to the Yaesu website‚ navigate to the FT-891 page and click on the files tab. You are looking for the USB driver and it is towards the bottom of the page labeled: FT-891/ SCU-17 USB Driver (Virtual COM Port Driver). Download this file.

What do I need to set up my ft-891?

To begin we will need the following: A Signalink Audio Interface with the USB cable and 6 pin data cable. The Signalink will need to be jumpered for the FT-891. You can do that yourself or purchase the Signalink jumper kit for that radio.

Does the ft-891 have a built in sound card?

Please try again later. While many newer transceivers have built in sound cards that make configuration for digital modes easier‚ the FT-891 does not have a built in sound card. So you will either need to use patch cables to move the audio between the computer and the transceiver‚ or use an audio interface like the Signalink.

Why is my ft-891 control not working?

There was a bug that was introduced in version 2.2.0 that broke the FT-891 control. The latest version 2.2.2 has the bug fixed‚ so if you are using 2.2.2 or later you should be fine.

image

Where is the CW message on a FT-891?

The CW message capability of the FT-891 may be utilized from the Front Control Panel, or the optional FH-2 Remote Control Keypad, which plugs into the rear panel REM/ALC jack .

How many seconds can a FT-891 hold?

The Voice Memory system includes five memories capable of storing up to 20 seconds of voice audio each. The maximum that any memory can hold is 20 seconds.

What is the CW frequency of FT-891?

That is, when receiving a signal at 14.100.00 MHz with a 700 Hz offset, the “zero beat” frequency of that CW carrier would be 14.100.70 MHz; which is what the FT-891 displays, by default. However, the display may be changed to be identical to what would be seen when listening on the USB mode, by using Menu item “07-11 ][CW FREQ DISPLAY ” and setting it to “FREQ” instead of the default “PITCH” setting.

What is FT-891 equalizer?

The FT-891 includes a unique Three-Band Parametric Microphone Equalizer that provides precise , independent control over the low , mid and treble ranges in the voice waveform. You may utilize one group of settings when the speech processor is off and use an alternate group of settings when the speech processor is on. U The Parametric Equalizer is a unique technique for adjusting the signal quality. The three audio ranges may be adjusted so precisely, it is possible to craft an audio response that provides a natural and pleasant sound that you may not have ever experienced before. Alternately, the effective “talk power” can be significantly enhanced. The configuration aspects that may be adjusted on the Parametric Equalizer are: Center Frequency: The center frequency of each of the three bands may be adjusted. Gain: The amount of enhancement (or suppression) within each band may be adjusted. Q: The bandwidth over which the equalization is applied may be adjusted.

Where is RTTY-PTT set?

9. RTTY-PTT and RTTY-SHIFT operations can be set from the Standard-COM port of the virtual COM port. On the computer, open Device Manager from the Control Panel to check the COM port number and set each item of the RTTY communication appli - cation.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9